Keithley 2601 Reference Manual page 403

Series 2600 System SourceMeter® Instruments Reference Manual
Table 13-15 (continued)
KIGeneral TSP test script: ConfigPulseIMeasureVSweepLog
TSP project name:
TSP test script name:
Firmware version:
Function:
ConfigPulseIMeasureVSweepLog
Usage:
f, msg = ConfigPulseIMeasureVSweepLog
(smu,bias,start,stop,limit,ton,toff,points,buffer,tag[,sync_in]
[,sync_out][,sync_in_timeout][,sync_in_abort])
Waveform
Return
Values
Output
Data
Example
See Also
2600S-901-01 Rev. C / January 2008
KIFactoryPulse
KIPulse
1.2.0 and later
A Boolean flag. This flag will be true when the pulse was successfully
f:
configured, false when errors were encountered.
A string message. If the f flag is false, msg will contain an error
msg:
message. Otherwise, msg will contain a string indicating successful
configuration.
Pulsed voltage measurements are stored in the reading buffer specified by the
buffer input argument.
ConfigPulseIMeasureVSweepLog(smua, 0, 1e-3, 0.01, 1, 1e-3,
10e-3, 10, smua.nvbuffer1, 5)
Set up a pulsed log sweep that will use SourceMeter Channel A. The pulsed
sweep will start at 1mA, end at 10mA, and return to a 0A bias level between
pulses. Each pulsed-step will be on for 1msec and then at the bias level for
10msec. The voltage limit will be 1V during the entire pulsed-sweep. The pulse
train will be comprised of 10 pulsed steps and the pulse train will be assigned a
tag index of 5.
InitiatePulseTest, InitiatePulseTestDual
Return to Section Topics
Section 13: Factory Scripts
13-25