Reset Function - Keithley 2601 Reference Manual

Series 2600 System SourceMeter® Instruments Reference Manual

reset function

This function is used to return all logical instruments to the default settings.
reset
Function Resets the logical instruments to the default settings.
Usage
reset()
This function resets all logical instruments in the system. This function is equivalent
Remarks •
to iterating over all the logical instruments in the system and calling the reset method
of each.
• Default settings are listed in
Details See "Default
serial functions and attributes
The functions and attributes in this group are used to configure the RS-232 Interface:
serial.baud
Attribute Baud rate for the RS-232 port.
Usage
baud = serial.baud
serial.baud = baud
baud
Remarks • A new baud rate setting takes effect when the command to change it is processed.
• The user should allow ample time for the command to be processed before attempting to
communicate with the instrument again. It is recommended that the baud rate be set from
the GPIB interface or from the front panel.
• The baud rate is stored in non-volatile memory. The reset function has no effect on the
baud rate.
Details See "RS-232 interface
Also see serial.databits, serial.flowcontrol,
Sets the baud rate to 1200:
Example
serial.baud = 1200
2600S-901-01 Rev. C / January 2008
Table 1-5.
settings" in Section 1.
-- Reads baud rate.
-- Writes baud rate.
Set to 300, 600, 1200, 2400, 4800, 9600,
19200 38400, 57600 or 115200.
operation" in Section
serial.parity
Return to Section Topics
11.
Section 12: Instrument Control Library
12-45