Keithley 2601 Reference Manual page 381

Series 2600 System SourceMeter® Instruments Reference Manual
Table 13-1 (continued)
KIGeneral TSP test script: PulseIMeasureV
TSP project name:
TSP test script name:
Firmware version:
Function:
PulseIMeasureV(smu, bias, level, ton, toff, points)
Parameters
Data
Example
Table 13-2
KIGeneral TSP test script: PulseVMeasureI
TSP project name:
TSP test script name:
Firmware version:
Function:
PulseVMeasureI(smu, bias, level, ton, toff, points)
Description
2600S-901-01 Rev. C / January 2008
KIFactoryGeneral
KIGeneral
1.0.2 and later
smu, bias, level, ton, toff, points
SourceMeter Channel (A or B). Defaults to SMU A if all parameters are
smu:
omitted when function is called.
bias:
level:
ton:
toff:
points:
Pulsed voltage measurements, current levels, and timestamps are stored in
smuX.nvbuffer1.
PulseIMeasureV(smua, 0.001, 1.0, 20E-3, 40E-3, 10)
SMU A will output 1mA and dwell for 20ms, output 1A and dwell for 20ms, and
then perform a voltage measurement. After the measurement, the output will
return to 1mA and dwell for 40ms. This pulse-measure process will repeat 9 more
times.
KIFactoryGeneral
KIGeneral
1.0.2 and later
Performs a specified number of pulse V, measure I cycles:
• Sets the to output
smu
• Sets the to output
smu
• Performs current measurement with source at
• Sets the to output
smu
• Repeats the above sequence for
Return to Section Topics
Bias level in amps.
Pulse level in amps.
Pulse on time in seconds.
Pulse off time in seconds.
Number of pulse-measure cycles.
volts and dwell for
bias ton
volts and dwell for
level
level
volts for seconds.
bias toff
pulse-measure cycles.
points
Section 13: Factory Scripts
seconds.
seconds.
ton
amps.
13-3