Keithley 2601 Reference Manual page 455

Series 2600 System SourceMeter® Instruments Reference Manual
NOTE (For firmware versions earlier then 1.2.0
Figure 16-1
Connections for voltage calibration
c. Perform each calibration step listed in
2600S-901-01 Rev. C / January 2008
calibration password in the smua.cal.unlock command. The
default Model 2601 password is "KI002601"; the default Model 2602
password is "KI002602".
Digital Multimeter
WARNING:
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY. NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
GUARD
SENSE HI LO SENSE
CHANNEL B
HI LO
GUARD
DIGITAL I/O
SENSE
CHANNEL B
HI
B LO
IEEE-488
MADE IN
U.S.A.
CAUTION: CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING. FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
Model 2636 channel A
connections shown
(Model 2611/2612), or Table 16-4
1) Select the range being calibrated with this command:
smua.source.rangev = range
Return to Section Topics
ubstitute the actual
, s
Input HI
Input LO
S LO
LO
HI
S HI
SENSE CHANNEL A SENSE
LO LO HI HI
GUARD
!
LINE FUSE LINE RATING
SLOWBLOW 100-240VAC
50, 60Hz
3.15A, 250V
240VA MAX.
RS-232
HI SENSE LO
LO
A LO
TSP-Link R
Table 16-2
(Model 2635/2636) as follows:
Section 16: Calibration
(Model 2601/2601) ,or Table 16-3
16-9