Series 2600 System SourceMeter® Instruments Reference Manual
To allow many parallel connections to one instrument, stack the connectors. Two screws are
located on each connector to ensure that connections remain secure.
connection scheme for a multi-unit test system.
To avoid possible mechanical damage, stack no more than three connectors on any one unit. To
minimize interference caused by electromagnetic radiation, use only shielded IEEE-488 cables.
Available shielded cables from Keithley Instruments are listed in
Section 1.
To connect the SourceMeter to the IEEE-488 bus, line up the cable connector with the connector
located on the rear panel. Install and tighten the screws securely, making sure not to overtighten
them
(Figure 11-3
2600S-901-01 Rev. C / January 2008
Figure 11-1
IEEE-488 connector
Figure 11-2
IEEE-488 connections
shows the location of the connections).
Return to
Section Topics
Section 11: Communications Interfaces
Figure 11-2
shows a typical
"Options and accessories"
in
11-3