Activating The Password - Eaton easySafety Manual

easySafety Settings
S PARAMETERS...Æ
STD PARAMETERS..
ACTIVATE PW
DELETE ALL
574
The password is now valid but not yet activated.

Activating the password

An already entered password can be activated in four ways
in order to activate password protection:
• via the password menu (see below)
• automatically when the device is switched on again.
• automatically after a configuration is loaded.
• automatically if 30 minutes after unlocking
– a telegram is not sent from easySoft-Safety via the
multi-function interface.
– a button is not actuated.
Activating password via the password menu
Enter the first page of the system menu and move to ACTI-
X
VATE PW.
Then press the OK button.
X
æ
h
Caution!
If the master and standard password are unknown or lost
and the interface was protected: The device can only be
restored to factory settings at the manufacturer. The
program and all data will be lost.
All passwords are now active. In other words, password
protection is active.
Before you then activate a protected function or protected
menu, you must unlock the device with the respective pass-
word or master password.
02/16 MN05013001Z EN