Eaton easySafety Manual page 542

easyNet network
NET_PARAMETERS..
STATION...
CONFIGURE
CONFIGURE?
CONFIGURATION
IN
PROGRESS.
538
h
Caution!
The SEND IO and REMOTE RUN parameters required for
operation are not transferred to the connected device with
the NET configuration.
If you require a parameter setting that is different to the
factory setting, you can do this locally via the NET
PARAMETERS menu of the NET station concerned. It is
much simpler, however, to change the parameter settings
via easySoft-Pro and easySoft-Safety in connection with a
program transfer or a transfer of the safety configuration
to the device concerned.
h
During the NET configuration, all connected stations
switch automatically to STOP. The NET LED for the stations
with NET ID 2-8 switches to OFF.
Procedure
Proceed to the CONFIGURE menu item and press the OK
X
button.
You will be asked to acknowledge whether you want to
configure the system.
Press OK.
X
The configuration is successfully completed if the message
on the left appears. The NET menu is displayed again and the
NET LEDs of all stations flash. The NET is operational.
Press the ESC key to exit the menu.
X
h
Any errors during the configuration are indicated by
messages or via the NET LEDs.
Further information can be found in section "Checking the
functionality of the NET" on page 543.
02/16 MN05013001Z EN