Eaton easySafety Manual page 373

02/16 MN05013001Z EN
EN01 NEN *** *
*** ***
>ED 3.0min
IS01 <- -
...
IS08 <- T1
...
IS12 <- T2
IS13 <- T3
IS14 <- -
The circuit diagram in easySafety has five rungs:
-------------------------------Ä OM01SA
OM01QS---IS08------------------Ä EN01SA
IS12---------------------------Ä EN01I1
IS13---------------------------Ä EN01I2
EN01QS-------------------------Ä MS05
Figure 183:
The enable contact of the overspeed monitoring function
block OM01QS and the key switch S1 at IS08 switch coil
EN01SA. The test signals T2 and T3 feed the enable switch
S2 connected to the device terminals IS12 and IS13.
The parameters for the enable are kept at the default setting
and the maximum permissible enable time is kept at 3.0
minutes.
The test signals for cross-circuit monitoring are assigned to
Æ
the corresponding device inputs in the TEST SIGNALSmenu.
æ
EN, enable switch
Enable switch example: Circuit diagram in
easySafety.
369