Eaton easySafety Manual page 222

Standard function blocks
C 16
>SH
>SL
>SV
QV>
218
Parameters
When using the function block in the circuit diagram for the
+
first time, use OK to automatically enter the general display
of function block parameters, as shown in the figure on the
left. Enter the function block settings here. The display
contains the following elements:
C 16
+
>SH
>SL
>SV
QV>
The parameters consist of the following:
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
"Parameter assignment from the standard circuit diagram"
on page 161.
Parameters
+
-
This parameter is factory set to +.
02/16 MN05013001Z EN
Function block: Counter relay, number 16
Parameter display: Call enabled
Upper setpoint
Lower setpoint
Start value (Preset)
Actual value
Function
Parameters are displayed
Parameters are not displayed