Eaton easySafety Manual page 243

02/16 MN05013001Z EN
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
"Parameter assignment from the standard circuit diagram"
on page 161.
Parameters
+
-
This parameter is factory set to +.
Outputs
Output QV> provides information on the status of the
selected safety function block.
A safety function block indicates its status in the form of a
hexadecimal code at the output DG (diagnostics register).
This code is also shown at output QV of the DG function
block.
h The section "Diagnostics-/-Error codes" on page 618 and
the online help section "DWord output of the safety
function blocks" provides further information on the
status messages and an overview of status messages and
codes.
Example:
Status number (code)
decimal
hex
8209
2011
DG, diagnostics
Function
Parameters are displayed
Parameters are not displayed
Status message
Foot switch (FS) not actuated
239