Eaton easySafety Manual page 577

02/16 MN05013001Z EN
j
h At least one area must be protected. In the default setting
the standard circuit diagram is selected.
• CIRCUIT DIAGRAM: The password is applied to the
standard circuit diagram as well as function blocks that
are not enabled, a section "Changing standard function
block parameters", page 167. This area also prevents the
transfer of a standard circuit diagram from and to the
memory card.
• PARAMETER: The PARAMETER menu is protected.
• CLOCK: Date and time are protected with the password.
• MODE: It is not possible to change the operating mode
from RUN to STOP and vice versa using the operating
buttons of the device concerned. The same applies for the
Run/Stop buttons of easySoft-Safety.
Danger!
This password protection does not prevent operating
mode changes in the following cases:
• With REMOTE RUN activated the NET station 2-8
follows the operating mode change of the NET station
with NET-ID 1, a section "Description of the NET-
PARAMETERs" ->„REMOTE RUN" on page 563.
• Operating mode changes can also be triggered through
local expansion units (communication modules).
• INTERFACE: Protects against access to the multi-function
interface of this device. Data exchange via the easyNet is
not affected. Take into account the restricting effect of a
protected interface if you have to reset the easySafety
device to factory settings (a section "Master password
no longer known", page 578).
• DELETE PROGRAM: When this function is not activated,
the question "DELETE PROG?" will appear if the standard
password entry is entered incorrectly four times. This
question does not appear if you activate this function and
protect the DELETE PROGRAM area. However, it is no
longer possible to make changes in protected areas if you
have forgotten the password.
Password protection
573