Eaton easySafety Manual page 101

02/16 MN05013001Z EN
l
IS07
L: 1 C:2 B:7704
---------Ä QR01
L: 1 C:5 B:7704
--------Ä ES01I1
L: 1 C:5 B:7704
Wiring
A easySafety device displays a small arrow l, the same tool
as already in the standard circuit diagram, the wiring arrow
l
(a page 89).
1rd circuit diagram line
Press ALT to activate the wiring arrow.
X
The cursor changes into a flashing wiring arrow and
automatically jumps to the first logical wiring position.
Press cursor button
X
is wired up to the coil field .
The cursor moves to the coil field which it indicates by
showing a flashing square
h
You can use DEL to erase a connection at the cursor or
arrow position. Where connections intersect, the vertical
connections are deleted first, then, if you press DEL again,
the horizontal connections are deleted.
Press OK to switch to Entry mode.
X
The set coil function
QR which is now flashing as an unfixed coil name is not. In
this example the contact IS07 will be wired with the the
function module input of coil ES..I1.
The output relay
.
ES01I1
Press the cursor button
X
ES.. appears in the coil field.
The coil name
and function block input
01
Press OK to select the function block
X
the coil name.
The cursor moves to coil
Press OK, to define function block ES01 via the following
X
coil number 01.
The first circuit diagram
í
four times so that the contact IS07
Ê
instead of the wiring arrow
Ä
is correct, but the device safety output
must therefore be changed to
QR01
Í Ú
or until the function block
will flash and the proposed coil number
ES
are displayed continuously.
I1
and flashes.
01
l
.
as an operand via
ES
97