Eaton easySafety Manual page 251

02/16 MN05013001Z EN
HW14 A +
>DY1
>DY2
>ON
>OFF
Wiring of the function block
You wire the function block in the standard circuit diagram
with its contact.
Example of a 7-day time switch:
HW14Q1---------------------------Ä QS01
Figure 105: Wiring of the function block contact
The 7-day time switch controls a device output directly.
Parameters
When using the function block in the circuit diagram for the
first time, use OK to automatically enter the general display
of function block parameters, as shown in the figure on the
left. Enter the function block settings here. The display
contains the following elements:
Function block: 7-day time switch, number 14
HW14
Time switch channel: A
A
Parameter display: Call enabled
+
Day 1: Start of the period
>DY1
Day 2: End of the period
>DY2
On time
>ON
Off time
>OFF
The parameters consist of the following:
HW, seven-day time switch
247