Eaton easySafety Manual page 282

Standard function blocks
278
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
"Parameter assignment from the standard circuit diagram"
on page 161.
Parameters Function
Parameters are displayed
+
Parameters are not displayed
-
This parameter is factory set to +.
Inputs
Function block input >K is used to define the input channel
to be supplied at function block output QV>.
Assign the values to function block inputs >I1 to >I8 that
you wish to output on function block output QV>.
Parameters Function
Channel number (0 - 7)
>K
Input value 1-8: - 2147483648 - +2147483647
>I1...>I8
The function block inputs >K and >I1 and >I8 can have the
following operands:
• Constant.
• Markers MD, MW, MB.
• Output ...QV> of a different function block.
02/16 MN05013001Z EN