Eaton easySafety Manual page 299

02/16 MN05013001Z EN
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
"Parameter assignment from the standard circuit diagram"
on page 161.
Parameters Function
Parameters are displayed
+
Parameters are not displayed
-
This parameter is factory set to +.
Input
When the function block is triggered, the value present at
function block input >I1 is temporarily stored and then
transferred to the NET.
Parameters Function
Input value: -2147483648 - +2147483647
>I1
The function block input can be assigned the following
operands:
• Constant.
• Markers MD, MW, MB.
• Output QV> of a different function block.
...
PT - Put value to the NET
295