Eaton easySafety Manual page 169

02/16 MN05013001Z EN
T 01 ?X M:S +
ââ:30
>I1
>I2
QV> MD96
T 01 ?X M:S +
ââ
>I1
>I2
QV> MD96
L:001 B:4312
Assigning operands at the output of a safety
function block
The actual value ...QV of a safety function block is normally
used to output the actual values of monitoring times or
frequencies.
You can assign the ...QV actual value output of a safety
function block to the MD, MW, MB markers or to the input
of certain standard function blocks in the standard function
block diagram. The assignment to a standard function block
input, e.g. to the I1 input of a DB data function block, is
made when defining the parameters for this input (I1 in the
example).
Deleting operands at standard function block
inputs/outputs
Position the cursor on the required operand.
Press the DEL button.
X
The operand is deleted.
Working with function blocks
165