Mounting - Eaton easySafety Manual

Installation

Mounting

40
Install a easySafety device in an enclosure, switch cabinet or
distribution board so that the power feed and terminal
connections cannot be touched accidentally during
operation.
Snap the device onto an IEC EN 60715 top-hat rail or fix it
vertically or horizontally in place using fixing brackets.
h When using the easySafety device with expansion units,
connect the expansion concerned before mounting
(a page 43).
For ease of wiring of the device, leave a gap of at least 3 cm
between the terminals and the wall or adjacent devices.
Figure 4: easySafetyclearances to the
02/16 MN05013001Z EN
30 mm
(1.18")
device.
30 mm
(1.18")