Eaton easySafety Manual page 164

Wiring with easySafety
TS01 S
*** ***
>T1 000.000
>T2 000.000
160
Parameter assignment from the safety circuit
diagram
The parameter dialog for the safety function block is opened.
The figure on the left shows a parameter dialog with the
X *
example of the safety function block TS, Safety timing relay.
Use the cursor buttons
X
changed, for example the time range.
Use the cursor buttons
X
to a different time range such as M:S.
Use cursor button
X
value T1.
Press OK to enter the Entry mode and then press cursor
X
button
Use the cursor buttons
X
confirm with OK.
Use cursor button
X
setpoint entry and enter this in the same way.
Use ESC to close the parameter dialog.
X
The values are now stored.
Complete the safety circuit diagram.
X
If you add the same function block in a different contact or
coil field once more to the safety circuit diagram and the
parameter dialog opens with the parameters already
assigned, you just have to press ESC to return to the previous
position without having to change parameters. Refer to
„Changing function block parameters" on page 166 for how
to change a parameter value or operand.
02/16 MN05013001Z EN
ú í
to select the parameter to be
ÍÚ
to change the parameter value
í
or OK to change to the first time set
í
until you have reached the digit to be entered.
ÍÚ
to set the constant value and
Ú
to enter the value of the second