Eaton easySafety Manual page 499

02/16 MN05013001Z EN
f Contact TS..QS: Value changes according to the operating
mode after expiry of reference times T1 and T2.
Used only in safety circuit diagram.
g Contact TS..ER: Closes in the event of an error.
Use in the safety and in standard circuit diagram.
h Actual value output TS..QV: Outputs the currently elapsed time.
Indicated on the device or in easySoft-Safety.
i Diagnostics output TS..DG: Provides information on the states
of the function block.
Evaluation only in the standard circuit diagram with the diag-
nostics function block DG.
Wiring of the function block
The safety timing relay uses various different coils and
contacts. Example of a timing relay function block:
IS01---------------------------Ä TS01SA
ES01QS-------------------------Ä TS01TR
MS01---------------------------Ä TS01ST
Figure 258: Wiring of input coils
You can associate the function block contact TS.QS directly
with one or several of the safety device outputs, for example:
L
TS01QS--------------------------uÄ QS01
Figure 259: Wiring the enable contact to two device outputs
TS, Safety timing relay
hÄ QS02
495