Eaton easySafety Manual page 166

Wiring with easySafety
AR01 ADD
CP10
T 01 ?X
L:001
162
Parameter setting in the function block editor
(standard function blocks)
Open the function block editor via the FUNCTION RELAYS
menu. Then first enter the function block list in which the
standard function blocks used are listed.
If no standard function blocks are shown, the list is empty.
ââ
L:001
In our example, the list contains the function blocks AR, CP
and T. The function blocks are created in the order in which
they were edited.
Displays the
function
blocks used
Current cursor
line
Figure 67: Explanation of the function block list
Use the cursor buttons
X
+
standard function block from the function block list, in this
+
case timing relay T01.
-
B:7420
The timing relay is shown in the function block editor and
can be fully assigned parameters here.
02/16 MN05013001Z EN
B:3100
Function, special function,
parameter display
AR01 ADD
CP10
T 01 ?X
L:001 B:7420
Free memory in bytes
ÍÚú í
to select the required
+
+
-