Eaton easySafety Manual page 342

Standard function blocks
C 01
>SH +10
>SL
>SV
338
Entering the standard circuit diagram
Enter the following circuit diagram.
X
IS05---------------------------Ä C 01C
IS06---------------------------Ä C 01RE
C 01OF-------------------------Ä T 01EN
T 01Q1-------------------------Ä QS01
Figure 171: Wiring of counter and timing relay
Entering function block parameters
When entering the coils or contacts of a function block, the
inputs/outputs of the function block are displayed to which
you can assign parameters. The parameters can be entered
via the function blocks menu.
The meaning of these parameters is explained under each
function block type.
Entry:
The first part of the parameter set of a counter is displayed.
+
Move the cursor
X
behind >SH:
– >SH means: Function block input upper counter
setpoint value.
– The + character means that the parameters of this
timing relay can be modified using the PARAMETERS
menu.
Change the upper counter setpoint to 10:
X
– Use
– Use
Press OK to save the value and ESC to return to the circuit
X
diagram.
Set the parameters for T 01.
X
02/16 MN05013001Z EN
í
over the + character to the value input
ú í
to move the cursor onto the tens digit.
ÍÚ
to modify the value of the digit.