Eaton easySafety Manual page 336

Standard function blocks
332
Function block: Table function, number 01
TB01
Parameter display: Call enabled
+
Input value
>I1
Output value
QV>
Number of table entries
QN>
The parameters consist of the following:
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
"Parameter assignment from the standard circuit diagram"
on page 161.
Parameters Function
Parameters are displayed
+
Parameters are not displayed
-
This parameter is factory set to +.
Input
The value at input >I1 is read into the table when function
block coil TB..WP is activated.
Parameters Function
Table input value:
>I1
-2147483648 - +2147483647
The function block input >I1 can be assigned the following
operands:
• Constant.
• Markers MD, MW, MB.
• Output QV> of a different function block.
...
02/16 MN05013001Z EN