Eaton easySafety Manual page 583

02/16 MN05013001Z EN
h
Caution!
Both reset procedures remove all circuit diagrams, param-
eters and passwords.
Reset with easySoft-Safety
Requirement: You have opened the communication view
and established the connection to the device (online).
Select Communication -> Factory Reset.
X
Enter the factory password CLEAR DEVICE.
X
The configuration is completely deleted.
h
When the multi-function interface is protected, you cannot
restore the device factory settings via easySoft-Safety. You
must first open the protected interface using the master or
standard password.
h If operating mode changes are protected, the only mode
in which the device can be reset to default settings
without entering the password is the STOP operating
mode. In the RUN operating mode, you will first have to
enable operating mode changes by entering the master
password or standard password.
Reset by the manufacturer
Your local Eaton branch will be glad to offer you further help
with the repair.
Password protection
579