Eaton easySafety Manual page 278

Standard function blocks
MR16 Q
274
Parameters
When using the function block in the circuit diagram for the
+
first time, use OK to automatically enter the general display
of function block parameters, as shown in the figure on the
left. Enter the function block settings here. The display
contains the following elements:
MR16
Q
+
The parameters consist of the following:
Operating mode
The mode setting allows you to set whether markers,
outputs or both are to be reset.
Parameters
Q
M
ALL
This parameter is factory set to Q.
Parameter display
The display of the parameters during operation can be
disabled. Further information can be found in section
"Parameter assignment from the standard circuit diagram"
on page 161.
Parameters
+
-
This parameter is factory set to +.
02/16 MN05013001Z EN
Function block: Master reset, number 16
Mode: Reset outputs
Parameter display: Call enabled
Function
Resets the outputs used in the standard circuit
diagram, S.., *S.., *SN..;
* = NET-ID
Acts on the marker range MD01 to MD96.
Acts on the operands specified above under Q
and M that are used in the standard circuit
diagram.
Function
Parameters are displayed
Parameters are not displayed