Eaton easySafety Manual page 242

Standard function blocks
DG01 +
QN>
QV>
238
Wiring a diagnostics function block
You wire the function block in the standard circuit diagram
with its coil and its contacts.
The enable coil of the DG function block is connected to a
device input.
IS05---------------------------Ä DG01EN
Figure 99: Wiring the coil in the standard circuit diagram
The contacts are assigned to markers.
DG01Q1-------------------------Ä M 01
DG01Q2-------------------------Ä M 02
DG01Q3-------------------------Ä M 01
DG01Q4-------------------------Ä M 04
DG01Q5-------------------------Ä M 05
DG01Q6-------------------------Ä M 06
DG01Q7-------------------------Ä M 07
DG01Q8-------------------------Ä M 08
DG01QC-------------------------Ä M 21
Figure 100: Wiring the output contacts
Parameters
When using the DG function block in the circuit diagram for
the first time, press OK to enter the general display of the
function block parameters automatically, as shown in the
figure on the left. This enables you to set the outputs QV and
QN. The display contains the following elements:
Function block: Diagnostics, number 01
DG01
Parameter display: Call enabled
+
Status code of the safety function block
QV
Display of all outputs Q1-Q8 of the DG function block
QN
The parameters consist of the following:
02/16 MN05013001Z EN