Checking The Transistor Output For Short-Circuit/ Overload - Eaton easySafety Manual

easySafety internal
630
least one cycle after the power supply is switched on. If the
standard circuit diagram is skipped, all the outputs retain
their previous state.
Checking the transistor output for short-circuit/over-
load
You can use diagnostics contact R15, R16 to scan whether a
short-circuit or overload is present at a transistor output of
an EASY620-DC-TE expansion device.
• R16: Group fault alarm for outputs S1 - S4.
• R15: Group fault alarm for outputs S5 - S8.
State
Fault alarms
No fault found
At least one output has
a fault
02/16 MN05013001Z EN
R15 or R16
0 = switched off (make contact)
1 = switched on (make contact)