Eaton easySafety Manual page 538

easyNet network
PROTECTION
SYSTEM
MENU LANGUAGE
CONFIGURATOR
NET..
LINK...
NET PARAMETER..
STATIONS...
CONFIGURE...
NET ID
BAUD RATE:125KB
BUSDELAY: 00
SEND IO
REMOTE RUN
534
Select the CONFIGURATOR menu option and press the OK
X
button.
h The following steps, starting from the opening of the NET
menu, are only possible in STOP mode.
Select the NET menu option and press the OK button.
X
Select the NET PARAMETERS menu option and press the
X
OK button.
Use the
X
Æ
: 01
case: NET ID 01) in the NET PARAMETERS menu and
confirm the setting with OK.
åæ
Move to the baud rate and set here the maximum
X
å
permissible transfer rate that your NET allows
(a page 669). This will save you any unnecessary delay
times:
The remaining parameters are not described further here.
They are described in detail on page 559.
h The functions REMOTE RUN and REMOTE IO are not
required for the station with NET ID 1 and are therefore
not available here. easySafety devices cannot be run in
REMOTE IO mode.
If all settings are ok, press ESC to exit the menu.
X
As you are currently parameterising the station with NET ID
1, you can now create the NET station list in the STATION
menu, then assign the NET IDs via the CONFIGURATION
menu and set a standard baud rate and bus delay time.
02/16 MN05013001Z EN
Í Ú
and buttons to assign the NET ID (in this