Delete Synchronized Action (Cancel) - Siemens SINUMERIK 828D Programming Manual

10.6

Delete synchronized action (CANCEL)

Function
The
from the part program.
If a synchronized action is canceled while the positioning axis movement that was activated
from it is still active, the positioning axis movement is interrupted. If this is not desirable, axis
motion can be braked with deletion of the axial distance-to-go before the
Syntax
CANCEL(<n1>,<n2>,...)
Significance
CANCEL
<n1>,<n2>,etc.
Examples
Example 1: Cancel synchronized action
Program code
N100 ID=2 WHENEVER $A_IN[1]==1 DO M130
...
N200 CANCEL(2)
Example 2: Delete distance-to-go before cancelling synchronized action
Program code
N100 ID=17 EVERY $A_IN[3]==1 DO POS[X]=15 FA[X]=1500
...
N190 WHEN ... DO DELDTG(X)
N200 CANCEL(17)
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
command can be used to cancel (delete) a modal or a static synchronized action
CANCEL
: Command to delete programmed synchronized actions
: Identification numbers of the synchronized actions to be deleted
Note:
If identification numbers are not specified, all modal/static
synchronized actions are deleted.
Motion synchronous actions
10.6 Delete synchronized action (CANCEL)
Comments
; Deletes modal synchronized action
no. 2.
Comments
; Start positioning axis motion.
; End positioning axis motion.
; Deletes modal synchronized action
no. 17.
command.
CANCEL
629