Programmable Servo Parameter Set (Scpara) - Siemens SINUMERIK 828D Programming Manual

Special Motion Commands

4.12 Programmable servo parameter set (SCPARA)

4.12 Programmable servo parameter set (SCPARA)
Function
The parameter set (comprising MDs) in the part program and in synchronized actions can be
programmed using
DB3n DBB9 bit3
To ensure no conflicts occur between PLC and NCK, an additional bit is defined on the
PLC → NCK interface:
DB3n DBB9 bit3 "Parameter set selection by SCPARA disabled".
If the parameter set input for
even programmed.
Syntax
SCPARA[<axis>]=<value>
Significance
SCPARA
<axis>
<value>
Note
The actual parameter set can be interrogated using the system variables
For
The PLC user program must be expanded if the servo parameter set is to be changed in a
part program, synchronized action or the PLC.
References:
/FB1/ Function Manual Basic Functions; Feedrates (V1),
"Feedrate Impact" section.
Example
Program code
...
N110 SCPARA[X]= 3
...
278
SCPARA
Define parameter block
Channel axis name (X, Y, ...)
Desired parameter block (1<= value <=6)
, or , the most suitable parameter set is selected by the control.
G33 G331 G332
Comments
; The 3rd parameter set is selected for axis X.
(up until now, only via the PLC).
is inhibited, then an error message is not output if this is
SCPARA
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
.
$AA_SCPAR[<axis>]
Job planning