Rotations Of The Tool Orientation (Orirota, Orirotr, Orirott, Orirotc, Theta) - Siemens SINUMERIK 828D Programming Manual

Transformations

6.4 Rotations of the tool orientation (ORIROTA, ORIROTR, ORIROTT, ORIROTC, THETA)

6.4 Rotations of the tool orientation (ORIROTA, ORIROTR, ORIROTT,
ORIROTC, THETA)
Function
If you also want to be able to change the orientation of the tools on machine types with
movable tools, program each block with end orientation. Depending on the machine
kinematics you can either program the orientation direction of the orientation axes or the
direction of rotation of orientation vector THETA. Different interpolation types can be
programmed for these rotation vectors:
● ORIROTA: Angle of rotation to an absolute direction of rotation.
● ORIROTR: Angle of rotation relative to the plane between the start and end orientation.
● ORIROTT: Angle of rotation relative to the change in the orientation vector.
● ORIROTC: Tangential angle of rotation to the path tangent.
Syntax
Only if interpolation type
programmed in all four modes as follows:
1. Directly as rotary axis positions
2. Euler angles (in degrees) with
3. RPY angles (in degrees) with
4. Direction vector via
If
ORIROTR
THETA
A rotation can also be programmed in a separate block without an orientation change taking
place. In this case,
always interpreted with reference to the absolute direction (
N... ORIROTA
N... ORIROTR
N... ORIROTT
N... ORIROTC
N... A3= B3= C3= THETA=value
N... PO[THT]=(d
344
ORIROTA
A3, B3, C3
or is active, the angle of rotation can only be programmed directly with
ORIROTT
.
and
ORIROTR
2 , d 3 , d 4 , d
is active can the angle of rotation or rotation vector be
A, B, C
A2, B2, C2
A2, B2, C2
(angle of rotation using
are irrelevant. In this case, the angle of rotation is
ORIROTT
Define the interpolation of the rotation vector
Define the rotation of the orientation vector
Interpolate angle of rotation with a 5th order
5 )
polynomial
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
)
THETA=value
).
ORIROTA
Job planning