Siemens SINUMERIK 828D Programming Manual page 180

Flexible NC programming
1.25 Subprogram technique
2nd return jump parameter 1 = "N200", return jump parameter 2 = 1
After the
block
3rd return jump parameter 1 = "N220", return jump parameter 3 = 2
After the
continued with block
180
command, program execution is continued with the block (
RET
in the main program.
N200
command, two program levels are jumped through and program execution is
RET
.
N220
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
) that follows
N210
Job planning