Siemens SINUMERIK 828D Programming Manual page 536

Axis couplings
9.5 Synchronous spindle
COUPOFS
COUPRES
COUPDEL
WAITC
<FS>
Optional parameters:
<LS>
<TFS>, <TLS>
<block change>
<coupling type>
<POSFS>
<POSFS>,<POSLS>
536
: Deactivating a coupling with stop of following spindle.
Block change as quickly as possible with immediate block change:
COUPOFS(<S2>,<S1>)
Block change only after passing the switch-off position:
COUPOFS(<S2>,<S1>,<POSFS>)
: Reset coupling parameters to configured MD and SD
: Delete user-defined coupling
: Wait for synchronized run condition
(NOC are increased to IPO during block changes)
: Designation of following spindle
: Designation of main spindle
Specification with spindle number: e.g.
: Transformation ratio between FS and LS.
<TFS>
Default: <
: Block change behavior
The block change is:
"NOC"
"FINE"
"COARSE"
"IPOSTOP"
The block change behavior is effective modally.
: Coupling type: Coupling between FS and LS
"DV"
"AV"
"VV"
The coupling type is modal.
:
Angle offset between leading and following spindles
Range of values:
: Switch-off positions of the following and leading spindles
"The block change is enabled once POS
passed"
Range of values:
= numerator, < = denominator
TLS>
/ < = 1.0 ; specification of denominator optional
TFS> TLS>
Immediately
On reaching "Synchronism fine"
On reaching "Synchronism coarse"
On reaching IPOSTOP; in other words, after
setpoint-based synchronism (default)
Setpoint linkage (default)
Actual value coupling
Speed coupling
0°... 359,999°
0°... 359,999°
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
,
S2 S1
, POS has been
FS LS
Job planning