Siemens SINUMERIK 828D Programming Manual page 391

Tool parameters $TC-DP1 to $TC-DP23 with contour tools
Note
The tool parameters not listed in the table, such as $TC_DP7, are not evaluated, i.e. their
content is meaningless.
Tool parameter number
(DP)
$TC_DP1
$TC_DP2
Geometry
$TC_DP3
$TC_DP4
$TC_DP5
Geometry
$TC_DP6
Geometry
$TC_DP10
$TC_DP11
Wear
$TC_DP12
$TC_DP13
$TC_DP14
$TC_DP15
Wear
$TC_DP19
$TC_DP20
Tool base dimension/
adapter
$TC_DP21
$TC_DP22
$TC_DP23
Basic value and wear value
The resultant values are each a total of the basic value and wear value (e.g. $TC_DP6 +
$TC_DP15 for the radius). The basic measurement ($TC_DP21 – $TC_DP23) is also added
to the tool length of the first cutting edge. All the other parameters, which may also impact on
effective tool length for a standard tool, also affect this tool length (adapter, orientational
toolholder, setting data).
Limit angles 1 and 2
Limit angles 1 and 2 each relate to the vector of the cutting edge center point to the cutting
edge reference point and are counted clockwise.
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Significance
Tool type
Tool nose position
Length compensation
Length 1
Length 2
Length 3
Radius
Radius
Limit angle
minimum limit angle
maximum limit angle
Length and radius compensation
Wear length 1
Wear length 2
Wear length 3
Wear radius
Limit angle
Wear min. limit angle
Wear max. limit angle
Length compensations
Length 1
Length 2
Length 3
Tool offsets
7.1 Offset memory
Cutting Dn Remarks
400 ... 599
391