Master/Slave Group (Masldef, Masldel, Maslon, Maslof, Maslofs) - Siemens SINUMERIK 828D Programming Manual

9.6 Master/slave group (MASLDEF, MASLDEL, MASLON, MASLOF,
MASLOFS)
Function
The master/slave coupling in SW 6.4 and lower permitted coupling of the slave axes to their
master axis only while the axes involved are stopped.
Extension of SW 6.5 permits coupling and uncoupling of rotating, speed-controlled spindles
and dynamic configuration.
Syntax
MASLON(Slv1,Slv2,..., )
MASLOF(Slv1,Slv2,..., )
MASLDEF(Slv1,Slv2,..., master axis)
MASLDEL(Slv1,Slv2,..., )
MASLOFS(Slv1, Slv2, ..., )
Note
For
preprocessing stop, the $P system variables for the slave axes do not provide updated
values until next programming.
Significance
General
MASLON
MASLOF
Dynamic configuration extension
MASLDEF
MASLOFS
MASLDEL
Slv1, Slv2, ...
Master axis
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0

9.6 Master/slave group (MASLDEF, MASLDEL, MASLON, MASLOF, MASLOFS)

, the implicit preprocessing stop is not required. Because of the missing
MASLOF/MASLOFS
Extension for dynamic configuration
Extension for dynamic configuring extension
Extension for slave spindle
Close (switch-in) a temporary coupling.
Open an active coupling. The extensions for spindles must be
observed.
Coupling user-defined using machine data or also
create/change from the part program.
Open the coupling analog to
slave spindle.
Uncouple master/slave axis group and delete group definition.
Slave axes led by a master axis.
Axis, that controls defined slave axes in a master/slave group.
Axis couplings
and automatically brake the
MASLOF
545