Siemens SINUMERIK 828D Programming Manual page 301

Program code
N700 G500
No_FRAME
M0
M30
Example of concatenating frames
Chaining of MEAFRAME for offsets
The
set frame
settable frame for further conversions for the procedure or machining.
Concatenation with ADDFRAME
If you want this offset frame in the frame chain to apply at a different position or if other
frames are active before the settable frame, the
chaining into one of the channel basic frames or a system frame.
The following must not be active in the frames:
● Mirroring with
● Scaling with
The input parameters for the setpoints and actual values are the workpiece coordinates.
These coordinates must always be specified
● metrically or in inches
● with reference to the radius
in the basic system of the controller.
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
5.6 Frame calculation from three measuring points in space (MEAFRAME)
function provides an offset frame. If this offset frame is concatenated with a
MEAFRAME( )
that was active when the function was called, e.g.,
$P_UIFR[1]
MIRROR
SCALE
(G71/G70)
Comments
;
;
ADDFRAME( )
and
(DIAMOF)
Coordinate transformation (FRAMES)
Deactivate settable frame as with
zero frame (no value entered,
pre-assigned).
Deactivate settable frame, as
pre-assigned with zero frame (no
value entered).
, one receives a
G54
function can be used for
301