Siemens SINUMERIK 828D Programming Manual page 701

Further information
Permitted traversing commands, coordinate system
The following G groups and G commands can be used for the contour programming:
G group 1:
G group 10:
G group 11:
G group 13:
G group 14:
G group 15:
In addition, the following are possible:
● Rounding and chamfer
● Circle programming using
The spline, polynomial and thread functions result in errors.
Changes to the coordinate system by activating a frame are not permissible between
CONTDCON
Replacing the geometry axes with
alarm.
Machining direction
The contour table generated using
direction of the contour.
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
, , ,
G0 G1 G2 G3
, ,
G60 G64 G641
,
G9
, ,
G70 G71 G700
,
G90 G91
, ,
G93 G94 G95
CIP
and . The same applies for a change between
EXECUTE
15.3 Generate coded contour table (CONTDCON)
,
G642
,
G710
, ,
G96 G961
and
CT
while preparing the contour table produces an
GEOAX
is used for stock removal in the programmed
CONTDCON
User stock removal programs
and or and
G70 G71 G700
.
G710
701