Program Sequence With Preprocessing Memory (Stopfifo, Startfifo, Fifoctrl, Stopre) - Siemens SINUMERIK 828D Programming Manual

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

Path traversing behavior

8.3 Program sequence with preprocessing memory (STOPFIFO, STARTFIFO, FIFOCTRL, STOPRE)

Program sequence with preprocessing memory (STOPFIFO,

STARTFIFO, FIFOCTRL, STOPRE)

Depending on its expansion level, the control system has a certain quantity of so-called

preprocessing memory in which prepared blocks are stored prior to program execution and

then output as high-speed block sequences while machining is in progress. These

sequences allow short paths to be traversed at a high velocity. Provided that there is

sufficient residual control time available, the preprocessing memory is always filled.

Designate machining step

The beginning and end of the machining step to be buffered in the preprocessing memory

are identified in the part program with

of the preprocessed and buffered blocks starts only after the

preprocessing memory is full.

Automatic preprocessing memory control

Automatic preprocessing memory control is called with the

initially works just like

preprocessing memory is full. However, the response to the emptying of the preprocessing

memory does differ: With

level reaches 2/3 in order to prevent complete emptying and deceleration to standstill.

Preprocessing stop

Programming the

The following block is not executed until all preprocessed and saved blocks have been

executed in full. The preceding block is halted in exact stop (as with G9).

. Whatever the programming, processing will not start until the

, the path velocity is reduced increasingly once the fill

command in a block will stop block preprocessing and buffering.

respectively. The processing

Programming Manual, 07/2010, 6FC5398-2BP40-0BA0

command or if the

Job planning

Show Quick Links

Table of Contents