Spline Grouping (Splinepath) - Siemens SINUMERIK 828D Programming Manual

Special Motion Commands

4.3 Spline grouping (SPLINEPATH)

4.3 Spline grouping (SPLINEPATH)
Function
The axes to be interpolated in the spline group are selected using the
Up to eight path axes can be involved in a spline interpolation grouping.
Note
If
SPLINEPATH
traversed as spline group.
Syntax
The spline group is defined in a separate block:
SPLINEPATH(n,X,Y,Z,...)
Significance
SPLINEPATH
n
X,Y,Z,...
246
is not explicitly programmed, then the first three axes of the channel are
Command to define a spline group
=1 (fixed value)
Identifier of the path axes to be interpolated in the spline group
SPLINEPATH
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
command.
Job planning