Siemens SINUMERIK 828D Programming Manual page 509

Significance
CTABDEL
<n>
<m>
<memory location>
If
CTABDEL
tables or all curve tables in the specified memory will be deleted:
CTABDEL ()
CTABDEL(,,"SRAM")
CTABDEL(,,"DRAM")
Note
If, in the case of multiple deletion with
the curve tables to be deleted is active in a coupling, the delete command will not be
executed; in other words, none of the addressed curve tables will be deleted.
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Command for deleting curve tables
Number (ID) of the curve table to be deleted
When a curve table range
to specify the number of the first curve table in the range.
When a curve table range
to specify the number of the last curve table in the range.
has to be greater than
<m>
Specification of memory location (optional)
In the case of deletion without a memory location being specified,
the specified curve tables are deleted in the static and the dynamic
NC memory.
In the case of deletion with a memory location being specified, of the
specified curve tables, only those located in the specified memory
location are deleted. The rest are retained.
"SRAM"
"DRAM"
is programmed without specification of the curve table to be deleted, then all curve
Deletes all curve tables in the static and the dynamic NC
memory
Deletes all curve tables in the static NC memory
Deletes all curve tables in the dynamic NC memory
CTABDEL(<n>,<m>)
CTABDEL(<n>,<m>)
.
<n>
Deletion in the static NC memory
Deletion in the dynamic NC memory
or
CTABDEL(<n>,<m>)
Axis couplings
9.2 Curve tables (CTAB)
is deleted,
<n>
is deleted,
<m>
, at least one of the of
CTABDEL()
is used
is used
509