Orientation Programming Along The Peripheral Surface Of A Taper (Oriplane, Oriconcw, Oriconccw, Oriconto, Oriconio) - Siemens SINUMERIK 828D Programming Manual

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

Transformations

6.2 Three, four and five axis transformation (TRAORI)

Orientation programming along the peripheral surface of a taper (ORIPLANE,

ORICONCW, ORICONCCW, ORICONTO, ORICONIO)

With extended orientation it is possible to execute a change in orientation along the

peripheral surface of a taper in space. The orientation vector is interpolated on the peripheral

surface of a taper using the ORICONxx modal command. The end orientation can be

programmed with ORIPLANE for interpolation on a plane. The start orientation is usually

defined by the previous blocks.

Programming Manual, 07/2010, 6FC5398-2BP40-0BA0

Job planning

Show Quick Links

Table of Contents