Siemens SINUMERIK 828D Programming Manual page 179

Subprogram subProg3:
Program code
PROC subProg3
N2000 R10=R20+100
N2010 ...
N2200 RET("subProg1")
Further information
The different effects of return jump parameters 1 to 3 are explained in the following graphics.
1st return jump parameter 1 = "N200", return jump parameter 2 = 0
After the
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
command, program execution is continued with block
RET
Comments
; Return jump into the main program at block N1550
Flexible NC programming
1.25 Subprogram technique
in the main program.
N200
179