Identifying Subprograms With Preparation (Prepro) - Siemens SINUMERIK 828D Programming Manual

Example 4: Display response in the case of different DISPLON/DISPLOF combinations
①
The part program lines from program level 0 are displayed in the current block display.
②
The part program lines from program level 3 are displayed in the current block display.
③
The part program lines from program level 3 are displayed in the current block display.
④
The part program lines from program level 7/8 are displayed in the current block display.
1.25.2.7

Identifying subprograms with preparation (PREPRO)

Function
All files can be identified with the
power up.
Note
This type of program preparation depends on the relevant set machine data. Please follow
the manufacturer's instructions.
References:
Function Manual, Special Functions, Preprocessing (V2)
Syntax
PROC ... PREPRO
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
keyword at the end of the
PREPRO
Flexible NC programming
1.25 Subprogram technique
operation line during
PROC
171