Suppress Current Block Display (Displof, Displon, Actblocno) - Siemens SINUMERIK 828D Programming Manual

Flexible NC programming
1.25 Subprogram technique
1.25.2.6

Suppress current block display (DISPLOF, DISPLON, ACTBLOCNO)

Function
The current program block is displayed as standard in the block display. The display of the
current block can be suppressed in cycles and subprograms using the
Instead of the current block, the call of the cycle or the subprogram is displayed. The
command can be used to revoke suppression of the block display.
DISPLOF
effective for the entire subprogram and implicitly for all subprograms called from it which do
not contain a
Syntax
PROC ... DISPLOF
PROC ... DISPLOF ACTBLOCNO
PROC ... DISPLON
Significance
DISPLOF
DISPLON
ACTBLOCNO
168
and are programmed in the program line with the
DISPLON
or
DISPLON DISPLOF
: Command to suppress the current block display.
Location:
Effective:
Note:
If further subprograms are called from the subprogram using the
command, then the current block display is also suppressed in these
subprograms unless
: Command for revoking suppression of the display of the current block
Location:
Effective:
Note:
If further subprograms are called from the subprogram using the
command, then the current block will also be displayed in these
subprograms unless
: together with the
DISPLOF
an alarm, the number of the actual block is output in which the alarm
occurred. The also applies if only
program level.
On the other hand, for
the cycle or subprogram call from the last program level not designated
with
DISPLOF
command. This is true of all ASUBs.
At the end of the program line with the
Up to the return jump from the subprogram or end of
program.
is explicitly programmed in them.
DISPLON
At the end of the program line with the
Up to the return jump from the subprogram or end of
program.
is explicitly programmed in them.
DISPLOF
ACTBLOCNO
DISPLOF
without
DISPLOF
is displayed.
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
DISPLOF
operation and are
PROC
PROC
PROC
attribute means that in the case of
is programmed in a lower
, the block number of
ACTBLOCNO
command.
DISPLON
operation
DISPLOF
operation
DISPLON
Job planning