Siemens SINUMERIK 828D Programming Manual page 410

Tool offsets
7.5 Activate 3D tool offsets (CUT3DC..., CUT3DF...)
Significance
CUT3DC
CUT3DFS
CUT3DFF
CUT3DF
G40 X... Y... Z...
ISD
Note
The commands are modally effective and written in the same group as
The command is not deselected until the next movement in the current plane is performed.
This always applies for
Intermediate blocks are permitted with 3D tool radius compensation. The definitions for
2 1/2D tool radius compensation apply.
Supplementary conditions
● G450/G451 and DISC
Example
Program code
N10 A0 B0 X0 Y0 Z0 F5000
N20 T1 D1
N30 TRAORI(1)
N40 CUT3DC
N50 G42 X10 Y10
N60 X60
N70 ...
410
G40
A circular block is always inserted at out corners.
The command is not evaluated.
DISC
Activation of 3D radius offset for circumferential milling
3D tool offset for face milling with constant orientation.
The tool orientation is determined by
influenced by frames.
D tool offset for face milling with constant orientation.
The tool orientation is the direction defined by
and, in some case, rotated by a frame.
3D tool offset for face milling with orientation change
(only with active 5-axes transformation).
To deactivate: Linear block
Insertion depth
and is independent of the
Comments
; Tool call, call tool offset values.
; Transformation selection
; 3D tool radius compensation selection
; Tool radius compensation selection
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
-
G17
/ with geometry axes
G0 G1
CUT2D
command.
CUT
have no significance.
G450/G451
and is not
G19
-
G17 G19
and .
CUT2DF
Job planning