Repositioning To A Contour (Reposa, Reposl, Reposq, Reposqa, Reposh, Reposha, Disr, Dispr, Rmi, Rmb, Rme, Rmn) - Siemens SINUMERIK 828D Programming Manual

Hide thumbs Also See for SINUMERIK 828D:

Table of Contents

8.6 Repositioning to a contour (REPOSA, REPOSL, REPOSQ, REPOSQA, REPOSH, REPOSHA, DISR,

Repositioning to a contour (REPOSA, REPOSL, REPOSQ,

REPOSQA, REPOSH, REPOSHA, DISR, DISPR, RMI, RMB, RME,

If you interrupt the program run and retract the tool during the machining operation because,

for example, the tool has broken or you wish to check a measurement, you can reposition at

any selected point on the contour under control by the program.

The REPOS command acts in the same way as a subprogram return jump (e.g., via M17).

Blocks programmed after the command in the interrupt routine are not executed.

For information about interrupting program runs, see also Section "Flexible NC

programming", Chapter "Interrupt routine" in this Programming Manual.

Job planning

Programming Manual, 07/2010, 6FC5398-2BP40-0BA0

Path traversing behavior

DISPR, RMI, RMB, RME, RMN)

Show Quick Links

Table of Contents