Grinding; Grinding-Specific Tool Monitoring In The Part Program (Tmon, Tmof) - Siemens SINUMERIK 828D Programming Manual

Grinding

13.1

Grinding-specific tool monitoring in the part program (TMON, TMOF)

Function
With the
(type 400 - 499) in the NC part program. Monitoring remains active until deactivated in the
part program using the
Note
Please follow the machine manufacturer's instructions!
Requirements
The grinding-specific tool parameters $TC_TPG1 to $TC_TPG9 must be set.
Syntax
TMON(<T-No.>)
TMOF(<T-No.>)
Description
TMON
TMOF
<T-No.>
TMOF(0)
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
command, you can activate geometry and speed monitoring for grinding tools
TMON
command.
TMOF
Command to switch-in the grinding-specific tool monitoring
Command to switch-out the grinding-specific tool monitoring
Specifies the T number
Note:
Only necessary if the tool with this T number is not active.
Deactivate monitoring for all tools
13
659