Siemens SINUMERIK 828D Programming Manual page 656

Punching and nibbling
12.2 Automatic path segmentation
Number of SPN path segments
SPN
The length of the segments is calculated automatically. Since
nibbling must be activated beforehand with
SPP and SPN in the same block
If you program both the path segment length (
the same block, then
activated before
Note
Provided that punching/nibbling functions are available in the control, then it is possible to
program the automatic path segmentation function with
technology.
656
defines the number of path segments to be generated from the total traversing distance.
applies to this block and
SPN
, then it takes effect again after the block with
SPN
is non-modal, punching or
SPN
or respectively.
PON SON
) and the number of path segments (
SPP
to all the following blocks. If
SPP
SPN
or
SPN SPP
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
) in
SPN
was
SPP
.
even independent of this
Job planning