Delete Additive Offsets (Deldl) - Siemens SINUMERIK 828D Programming Manual

7.2.3

Delete additive offsets (DELDL)

Function
The
memory space). Both the defined wear values and the setup values are deleted.
Syntax
DELDL[<t>,<d>]
DELDL[<t>]
DELDL
<Status>=DELDL[<t>,<d>]
Significance
DELDL
<t>
<d>
DELDL[<t>,<d>]
DELDL[<t>]
DELDL
<status>
Note
Wear and setting-up values of active tools cannot be deleted (essentially the same as the
delete behavior of
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
command deletes the additive offsets for the cutting edge of a tool (to release
DELDL
Command to delete additive offsets
T number of the tool
D number of the tool cutting edge
All additive offsets of the cutting edges
deleted.
All additive offsets of all cutting edges of tool
All additive offsets of all cutting edges of all tools of the TO unit are
deleted (for the channel in which the command is programmed).
Delete status
Value: Significance:
0
-
or tool data).
D
Deletion was successfully completed.
Offsets have not been deleted (if the parameter settings
specify exactly one tool edge), or not deleted completely (if
the parameter settings specify several cutting edges).
Tool offsets
7.2 Additive offsets
of the tool are
<d> <t>
are deleted.
<t>
395