Deselect Transformation (Trafoof) - Siemens SINUMERIK 828D Programming Manual

Transformations

6.11 Deselect transformation (TRAFOOF)

6.11 Deselect transformation (TRAFOOF)
Function
The
Note
Frames required after this must be activated by renewed programming.
Please note:
The same restrictions as for selection are applicable to deselecting the transformation (see
section "Constraints when selecting a transformation").
Syntax
TRAFOOF
Significance
TRAFOOF
386
command deactivates all active transformations and frames.
TRAFOOF
Command for deactivating all active transformations/frames
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Job planning