Polynomial Interpolation (Poly, Polypath, Po, Pl) - Siemens SINUMERIK 828D Programming Manual

Hide thumbs Also See for SINUMERIK 828D:
Table of Contents

Advertisement

4.5

Polynomial interpolation (POLY, POLYPATH, PO, PL)

Function
It actually involves a polynomial interpolation (
main purpose is to act as an interface for programming externally generated spline curves
where the spline sections can be programmed directly.
This mode of interpolation relieves the NC of the task of calculating polynomial coefficients.
It can be optimally applied in cases where the coefficients are supplied directly by a CAD
system or post processor.
Syntax
3rd degree polynomial:
POLY PO[X]=(xe,a2,a3) PO[Y]=(ye,b2,b3) PO[Z]=(ze,c2,c3) PL=n
5th degree polynomial and new polynomial syntax:
POLY X=PO(xe,a2,a3,a4,a5) Y=PO(ye,b2,b3,b4,b5) Z=PO(ze,c2,c3,c4,c5)
PL=n
POLYPATH("AXES","VECT")
Note
The sum of the polynomial coefficients and axes programmed in an NC block must not
exceed the maximum permitted number of axes per block.
Meaning
POLY
POLYPATH
PO[axis identifier/variable]
X, Y, Z
e
x
a2, a3, a4, a5
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
:
:
:
:
, ye, ze
:
4.5 Polynomial interpolation (POLY, POLYPATH, PO, PL)
) and not a spline interpolation type. Its
POLY
Activation of polynomial interpolation with a block
containing POLY.
Polynomial interpolation can be selected for both
AXIS or VECT axis groups
:
End points and polynomial coefficients
Axis identifier
Specification of end position for the particular axis;
value range as for path dimension
The coefficients a
their value; value range as for path dimension. The
last coefficient in each case can be omitted if it
equals zero.
Special Motion Commands
, a
, a
, and a
are written with
2
3
4
5
251

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents